7.2 ON
Select On to manually turn Daylight Savings Time On. This is the default
selection;
7.3 AUTO
When selected the Daylight Savings Time offset is automatically changed.
8. Press [CLR] or move the ShuttlePoint knob to the left until the Chart page is shown.
3.3
SELECTING LORAN TD OR OTHER COORDINATE SYSTEM
The GPS Fix coordinates can be changed to show Latitude/Longitude, Loran TDs or UTM.
Below is the window that will appear when customizing the Coordinate System.
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press
[ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight NAVIGATE and press [ENT] or move the
ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight COORDINATE SYSTEM and press [ENT] or
move the ShuttlePoint knob to the right.
5. Move the ShuttlePoint knob to highlight the desired coordinate type and press [ENT] or
move the ShuttlePoint knob to the right.
6. Press [CLR] or move the ShuttlePoint knob to the left until the Chart page is shown.
If the TD is selected, you should set the Chain, Pair, ASF1, ASF2 and Alter. If the TD numbers are
not correct the Pair letters may be backwards. Reversing the two letters usually solves this issue.
Example: Y/Z change to Z/Y.
3.4
CHANGING THE CHART COLOR
The CP390i and CPF390i have preprogrammed settings allowing you to customize the look
of the Chart page. The default is Sunlight, however there are other settings: Classic, NOAA,
Night and Normal. Night is very useful during evening hours so not to impair night vision.
Page 34
Figure 3.3 - Coordinate System Menu
NOTE
Figure 3.4 - Display Color Menu
CP390i and CPF390i