Selecting Loran Td Or Other Coordinate System; Changing The Chart Color - Standard Horizon CP500 Owner's Manual

the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight TIME SETUP and press [ENT] or move the
ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight TIME ZONE and press [ENT] or move the
ShuttlePoint knob to the right.
5. Look at the table and find the time zone for your area. Move the ShuttlePoint knob up
or down to select the desired zone and press [ENT].
6. Next move the ShuttlePoint knob to highlight DAYLIGHT SAVING and press [ENT] or
move the ShuttlePoint knob to the right.
7. Daylight Savings menu has 3 options:
7.1 OFF Select Off when your location does not recognize Daylight Savings Time;
7.2 ON Select On to manually turn Daylight Savings Time On. This is the default
selection;
7.3 AUTO When selected the Daylight Savings Time offset is automatically changed.
8. Press [CLR] or move the ShuttlePoint knob to the left until the Chart page is shown.
3.3

SELECTING LORAN TD OR OTHER COORDINATE SYSTEM

The GPS Fix coordinates can be changed to show Latitude/Longitude, Loran TDs or UTM.
Below is the window that will appear when customizing the Coordinate System.
1. Press [MENU], move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight NAVIGATE and press [ENT] or move the
ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight COORDINATE SYSTEM and press [ENT] or
move the ShuttlePoint knob to the right.
5. Move the ShuttlePoint knob to highlight the desired coordinate type and press [ENT] or
move the ShuttlePoint knob to the right.
6. Press [CLR] or move the ShuttlePoint knob to the left until the Chart page is shown.
If the TD is selected, you should set the Chain, Pair, ASF1, ASF2 and Alter. If the TD numbers are
not correct the Pair letters may be backwards. Reversing the two letters usually solves this issue.
Example: Y/Z change to Z/Y.
3.4

CHANGING THE CHART COLOR

The GPS Chart Plotter has preprogrammed settings allowing you to customize the look of
the Chart page. The default is Sunlight, however there are other settings: Classic, NOAA,
Night and Normal. Night is very useful during evening hours so not to impair night vision.
CP500
Figure 3.3 - Coordinate System menu
NOTE
Page 27