Selecting Loran Td Or Other Coordinate System; Changing The Chart Color - Standard Horizon CP180 Owner's Manual

3.3

SELECTING LORAN TD OR OTHER COORDINATE SYSTEM

The GPS Fix coordinates can be changed to show Latitude/Longitude, Loran TD's or UTM.
Below is the window that will appear when customizing the Coordinate System.
1. Press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight ADVANCED SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight NAVIGATE and press [ENT] or move the
ShuttlePoint knob to the right.
4. Move the ShuttlePoint knob to highlight COORDINATE SYSTEM and press [ENT] or
move the ShuttlePoint knob to the right.
5. Move the ShuttlePoint knob to highlight the desired coordinate type and press [ENT] or
move the ShuttlePoint knob to the right.
6. Press [CLR] or move the ShuttlePoint knob to the left until the Chart page is shown.
If the TD is selected, you should set the Chain, Pair, ASF1, ASF2 and Alter. If the TD numbers are
not correct the Pair letters may be backwards. Reversing the two letters usually solves this issue.
Example Y/Z change to Z/Y.
3.4

CHANGING THE CHART COLOR

The GPS chart plotter has preprogrammed settings allowing you to customize the look of
the Chart page. The default is "Sunlight" however there are other settings; Normal, Classic
and Night. Night is very useful during evening hours so not to impair night vision.
1. Press [MENU]. Move the ShuttlePoint knob to highlight SETUP MENU and press [ENT].
2. Move the ShuttlePoint knob to highlight GENERAL SETUP and press [ENT] or move
the ShuttlePoint knob to the right.
3. Move the ShuttlePoint knob to highlight DISPLAY COLOR and press [ENT] or move the
ShuttlePoint knob to the right.
CP180 / CP180i
Figure 3.3 - Coordinate System menu
NOTE
Figure 3.4 - Display Color menu
Page 27