SERVICE INFORMATION
BULB REPLACEMENT
IGNITION SWITCH
SERVICE
INFORMATION
GENERAL
A
continuity test can be made with the switches installed on the vehicle.
reconnecting.
To isolate an electrical failure, check the continuity of the electrical path through the part.
ally be made without removing the part from the vehicle. Simply disconnect the connectors and connect a continuity
tester to the terminals or connections.
SPECIFICATIONS
I
Bulbs
Fuse (main fuse)
TORQUE VALUES
Headlight mounting bolt
Neutral switch
18-1
18-2
18-3
ITEM
Headlight (High/low beam)
Taillight
Neutral indicator
4 N m (0.4 kgfm, 2.9 IbfW
13 N.m (1.3 kgfm. 9 IbfW
LIGHTS/SWITCHES
18.
HANDLEBAR SWITCH
CLUTCH SWITCH
NEUTRAL SWITCH
be
released before disconnecting, and must be aligned when
A
continuity check can usu-
SPECIFICATIONS
v
w
12
x 2
-
v -
12
1 5 A
18-4
18-4
18-5
I
18-1