Input Setup - SoundCraft Si Impact User Manual

CHANNELS & BUSSES
channel naming, lin ing, LR or LCR Panning / routing, Pre/Post routing options for Mix Busses and Direct
Outputs, and physical input and Direct Output patching.
N me
Name the selected input channel.
When the Name field is selected, a QWERTY keyboard will appear on the Touch Screen so you can enter the desired
name.
Is l te
Isolate this channel from automation playbac .
When a new cue is loaded, this channel will not be affected and its setting will not be changed. However, current
channel settings are still stored when a cue is stored.
Please note: To prevent conflict, Isolation function does not include 48V and pre-amp gain.
T e
An input channel can either be Mono, Lin ed, or Stereo.
Stereo channels on this console are fixed as ST1 - ST4 and therefore the Type parameter is not editable. Mono Chan-
nels can be linked in consecutive Odd/Even pairs. Linked mono channels act in unison though the 48V and phase
buttons, and the Delay, Gain, and Pan controls remain independent.
P n M
Set Pan mode for this channel to LR (Left Right) or LCR (Left Centre Right).
Routing/Panning for the Main Mix Bus. In LCR mode the Main Mono Mix Bus is used as the Centre channel. Mono
routing must be enabled in the ACS (Assignable Channel Strip) OUTPUT section for this to work.
User Manual
INPUT CHANNELS
e
6.1.1: CHANNELS & BUSSES
SETUP
INPUT CHANNELS

6.1.1: INPUT SETUP

INPUT SETUP