Ricoh FT4480 Field Service Manual page 82

9. Set new pick-off pawls [A] on the shaft [B] and position them with
the positioning pins [C] and pawl springs [D].
Assemble the pawl shaft assembly and set it on the cleaning unit
10.
sliding in the rear end of the shaft to the rear side plate.
When installing the cam holder [E] and the cam rider [F], align X with Y
NOTE: -
as shown in the figure.
- Make sure that the spring end is in the small hole on the rear side
plate.
11. Install the pawl shaft pin [G].
12. Push the spring collar [H] to the rear and rotate it with one turn as
shown in the figure. Then set the collar on the pin.
NOTE: Make sure that the end of the spring is correctly positioned in the groove
of the collar.
13. Reassemble.
3-31
15 MARCH 1987