Ricoh FT4480 Field Service Manual page 202

15 MARCH 1987
4. Install the clamps [A] on the editor as shown in the figure.
5.
Plug a stylus jack into the editor as shown.
6. Remove the screw securing the bottom plate as shown and secure
the lock plate [B] to the bottom plate.
NOTE: Step 6 is only required in the 220/240V machine.
7. Secure the stylus pen harness [C] and connector harness [D] in the
clamps.
8. Install the hinges [E] on the editor (6 screws each).
9. Install the hinge bracket [F] on the hinges (2 screws).
NOTE: Use the screws which secure the platen cover to the machine.
8-6