Ricoh FT4480 Field Service Manual page 59

15 MARCH 1987
10. Run
the scanner drive wire over the pulleys in the following order:
1) Long end should be in the outer track (WP1).
2) Lower side (wire clamp [A])
3) Lower track (WP2)
4)
Three and a half turns from lower to upper (Scanner Drive Pulley
[B]).
5) Lower track (WP3).
6) Inner track (WP1).
7) Track (WP4).
11. Pull the ends of the wire together and join them with the tension
spring. (See the preceding page.)
12. Rotate the scanner drive pulley and make sure that the scanner drive
wire moves smoothly and that there is no overlapping around the
scanner drive pulley.
NOTE: Step 12 is important! If overlapping of the scanner drive wire occurs, then
the trail edge of A3 (11" x 17") copies may be reduced.
3-8