8. Remove the rear cover and lower the PCB plate (2 screws each).
9. Remove the transport and separation power pack (1 screw).
10. Disconnect the vacuum fan connector [A] (2p White) just under the
main motor.
11. Remove the transport unit from the mounting bracket [B] (2 screws).
12. Slide the transport unit and vacuum fan out of the copier.
NOTE: When reinstalling the transport unit, be sure the transport gear meshes
with the drive gear.
13. Remove the front of the transport unit as shown (1 E-ring, 1 spring
[ C ] a n d 1 s h a f t [ D ] ) .
14. Pull the right transport roller [E] and transport belt [F] to the right and
remove the transport rollers [G].
15. Remove the transport belt as shown.
3-65
15 MARCH 1987