Ricoh FT4480 Field Service Manual page 190

15 MARCH 1987
- Common Procedure for Front and Rear Wire -
NOTE: The running directions for the front and rear wires are opposite.
1. Loosen the wire tightener [A] (1 screw).
2. Insert the bead [B] (unmarked) into the rear slot of the drive pulley.
3. Loop the wire around the drive pulley [C], as shown (one and a half
turns).
4. Run the wire over WP1, WP2, WP3, and WP4 in turn while also
placing the lift rod's ends in the braces.
5. Insert the bead [D] (red) into the other slot of the drive pulley.
6. Loop the wire around the drive pulley, as shown (two and a half
turns).
7. Hook the wire on the tightener pulley [E].
8. Move the rods up and down manually to ensure that the drive wire
does not overlap on the pulley.
9. Tighten the wire using the tightener (1 screw).
10. Reassemble.
7-8