Table of Contents
Advertisement
10.
Remove the rear cover (2 screws) and remove the right docking hole
cover [A].
11.
Remove the cap [B] from the right docking hole cover using a small
screw driver as shown in the figure.
12.
Connect the editor connector (8 pin) [C] through the the docking hole
and reinstall the docking hole cover on the copier.
13.
Clamp the editor harness to the main board bracket with the nylon
wire clamp then reinstall the rear cover.
14.
Install the editor on the copier.
15.
Put the pressure sheet [D] on the exposure glass so as to align the
image area indicators.
16.
Remove the tape seal.
17.
Close the editor to complete the installation of the pressure sheet
and the editor.
18.
Check the operation of the editor.
19.
Fill out the New Equipment Condition Report.
8-7
15 MARCH 1987
Advertisement
Chapters
Table of Contents
