Ricoh FT4480 Field Service Manual page 108

10. Remove the hot roller gear [A], bearings [B], and the collars [C] from
both ends of the hot roller [D] (1 C-ring each).
11. Slide the hot roller slightly to the rear and remove the hot roller as
shown.
12. Tear the protective paper [E] from the ends of a new hot roller and
install it.
13. After the new hot roller is installed, remove the protective paper.
NOTE: When reinstalling the fusing lamp, make sure it does not touch the inside
of the hot roller.
3-57
15 MARCH 1987