Table of Contents
Advertisement
15 MARCH 1987
CAUTION:
On the following step, avoid bending the fiber optics sharply; this will
damage the fiber optics.
14.
Pass the DF interface harness [A] through the harness hole [B] of the
DF and the docking hole of the copier [C].
15.
Connect the DF interface harness to the DF PCB [D] (3 connectors).
NOTE: The fiber optics connectors [E] have different colors. Be sure to match
these colors when making these connections.
16.
Secure the DF ground wire [F] on the DF base plate (1 ground screw
and toothed washer).
17.
Open the DF and install the nylon harness bushing [G] from the
underside. (This harness bushing should be positioned around the vinyl
tube [H] of the DF harness as shown.)
5-6
Advertisement
Chapters
Table of Contents
