Ricoh FT4480 Field Service Manual page 151

15 MARCH 1987
11. Install the original feed table [A] on the right side of the belt unit [B]
(2 screws with washer). Be sure to engage the 2 hooks [C] of the
original table with the docking holes [D] of the belt unit.
12. Install the original table cover [E] under the original table (4 screws).
13. Level the DF as follows:
a) Remove the DF grip plate [F] (2 screws).
b)
Place 2 sheets of A3 (11" x 17") paper between the white belt
guide spacers [G] and the exposure glass.
c) Loosen the mounting screws of the right side magnetic catch [H].
Push down the right side of the magnetic catch bracket [I], then
tighten the screws of the right magnetic catch. Repeat this
process with the left side magnetic catch.
d) Remove the 2 sheets of paper.
5-4