Ending/Holding/Continuing Call By Folding The Foma Terminal; Close Settings; Priority Comm Mode; Putting A Call On Hold When You Cannot Answer Immediately - Docomo F-01A Instruction Manual

Close settings

Ending/Holding/Continuing call by folding the
FOMA terminal
This function does not operate during 64K data communication, packet
communication.
Setting when folded P79
m [Settings & NW services] 572e1-3
1
✔INFORMATION
In the cases below, the call continues even if FOMA terminal is folded.
- When Flat-plug Earphone/Microphone with Switch (optional) is connected.
- When a device that is connected to handsfree is set to sound
- When message is being recorded by Answer machine.
When a call is placed"On-hold", On-hold is deactivated when FOMA terminal is opened
again.
When setting to "Continue (mute)", if speakerphone is active, your voice is not heard by
the other party but you hear the other party's voice from the speaker. When sending
camera image during videophone call, substitute image is sent to the other party.
Operations during voice call : m6

Priority comm mode

Setting the priority screen for an incoming call
during another call
You can select the voice call or packet communication screen to be given priority
when data is received via packet communication from a connected PC during a
voice call or when a voice call is received during i-mode communication.
A screen change caused by this function does not suspend the call or packet
communication.
When i-mode mail or MessageR/F is received during voice call, voice call screen
appears by priority.
When a voice call is received while accessing data broadcasting site, Call alert
image appears by priority. P218 "Time shift function"
m [Settings & NW services] 561e1-3
1
When this is set to "No Set Up", the incoming screen for the newest call
appears. However, voice call screen appears when packet transmission is
received during voice call.
68
Voice/Videophone Calls/PushTalk
When "Packet" is set, packet communication screen appears during voice call,
and i-mode screen appears during i-mode session. You can switch to the call
screen by pressing s from Switch Task menu.
When you can/could not answer a voice/videophone call

Respond and Hold

Putting a call on hold when you cannot answer
immediately
The caller is charged for time spent in Respond hold.
While receiving a call, f
1
The call is put on hold, and the other party hears a status message. For
videophone call, response hold image for videophone is displayed to you and
the other party.
When you are ready to answer the call, n
2
You can also answer videophone call by pressing I.
If f is pressed or the caller hangs up while on hold, the call ends.
Setting Status message
You can record a status message up to approximately 10 seconds in your own
voice.
m [Settings & NW services] 1181eSelect On-hold
1
tone fielde2
Press 1 and go to Step 3 to restore preinstalled guidance.
2
"Record" in Edit message fieldeRecord the greeting message after
the beep
Recording starts after a message appears.
An end tone (beep) sounds approximately 10 seconds after the start of
recording.
Press g to stop recording halfway.
When a recorded status message is deleted, the preinstalled message is
reset.
Select "Play" to check a status message.
C
3