Keypad Sound - Docomo F-01A Instruction Manual

Setting System sound
Keypad sound : Set a sound to be emitted when pressing keys (except P, M, SD),
operating pointing device or operating in flip style.
When the sound of Battery level and End alert of Data exchange settings are set
to "ON", sounds are emitted according to these settings.
When setting to "OFF", the confirmation sound is not emitted when reading a
code.
Keypad sound is not emitted in the cases below even if it is set to ON.
- When i-αppli is activated (except s)
- When Full Browser is activated, or when the pointer is moved by sliding the pointing device
- When sliding or quickly sliding in flip style
When setting to "Sol-fa", the dedicated sound is emitted by double-tapping the
pointing device, "Key sound 2" is emitted by sliding the pointing device or
touching or double-touching in flip style.
Open/Close sound : Set a sound to be emitted when opening/closing FOMA
terminal.
Shutter sound : Set a shutter sound when shooting a still image.
This setting also applies to Shutter sound of Image settings.
Movie camera sound : Set a shutter sound when recording a movie (including
recording a sound with Sound recorder).
This setting also applies to Shutter sound of Recording settings.
m [Settings & NW services] 116
1
2
Perform necessary operation
1e1-5
Setting Keypad sound :
Setting Open/Close sound :
3e1-5
Setting Shutter sound :
Setting Movie camera sound :
94
Sound/Screen/Light Settings
2e1-4
4e1-5
Charge alert
Setting confirmation tone for charging
You can set if you activate the battery charging sound at the start and end of
charging.
m [Settings & NW services] 117e1 or 2
1
✔INFORMATION
Even when "ON" is set, the charge alert does not sound in the cases below.
- In Silent mode, Public mode (Drive mode), during a voice/videophone call, PushTalk session, 64K
data communication, i-mode communication, packet communication
Setting Call session
On-hold tone : Set On-hold tone.
Quality alarm : Set alarm sound when the call is about to be interrupted.
The call may be interrupted without sounding the alarm depending on the call
conditions or radio wave conditions.
Reconnect alarm : Set alarm for reconnecting interrupted call.
While the call is interrupted, the other party hears no sound.
The time required for reconnection differs depending on the call conditions or
radio wave conditions. It normally takes 10 seconds at most.
You are charged for the time used for reconnection (up to 10 seconds).
The call may be interrupted without sounding the alarm depending on the call
conditions or radio wave conditions.
Low Battery alert : Set if you activate the alarm when the battery is about to be
exhausted.
When the battery becomes low during a call, the alert is emitted from the earpiece
even with "OFF" set.
m [Settings & NW services] 118
1
2
Perform necessary operation
2e1-3
Setting On-hold tone :
3e1-3
Setting Quality alarm :
Operation during a voice call : m5
4e1-3
Setting Reconnect alarm :
Operation during a voice call : m4