Charging - Docomo F-01A Instruction Manual

Removing
a Perform the procedure a-b of Attaching.
b Pinch the tab of battery pack and pick it up in the direction of the arrow to
remove.
✔INFORMATION
Attaching battery pack forcibly into FOMA terminal may damage FOMA terminal jack.
FOMA terminal or back cover may be damaged if you install or remove battery pack by
a method except the procedures above or if you press too hard.
To prevent water seepage, install back cover firmly and lock it with the lever.
The rubber packing of the inner lid has an important function to maintain waterproof
performance. Do not remove or damage it. Also, prevent dust from adhering to it.
50
Before Using the Handset
❖
For better battery pack performance
Do not charge the battery for an extended period (several days) with FOMA
terminal turned ON.
After charging has completed with FOMA terminal turned ON, the power is
supplied to the terminal from the battery pack. If FOMA terminal is left in that state
for a long time, the battery pack may run out causing the low battery alert to
Tab
sound after using only a short period of time. In this case, remove FOMA terminal
from the AC adapter, desktop holder or DC adapter and then reconnect it and
charge the battery again.
To promote environmental conservation, return your used battery pack to NTT
DOCOMO sales outlets, our corporate agencies or the shops that collect used
battery in your community.

Charging

The battery pack does not have a full charge at time of purchase. Use AC/DC
adapter for FOMA terminal to charge the battery before using FOMA terminal.
To get the maximum performance from F-01A, use battery pack F10.
❖
Charging times (approximate)
The times below are the times for charging an empty battery pack with F-01A's
power switched OFF. Charging with the terminal ON or under low temperature
requires longer time.
AC adapter
DC adapter
Approx. 150 min.
Approx. 150 min.