Listen Volume - Docomo F-01A Instruction Manual

If videophone call was not connected, a message appears indicating the reason and
stand-by display reappears. Displayed messages may not reflect the state of the other
party correctly depending on the type of terminal and/or usage of the network service
by the other party. Main messages are as below.
- Busy. : The line of the other party is busy (may appear during packet communication on some types
of the other party's terminal)
- Set Caller ID to ON : Caller ID is not sent (such as when connecting to visualnet)
- Redial using voice call : The other party is set for Call Forwarding Service but forwarding
destination does not support videophone calls
- Busy with packet transmission. : The other party is performing packet transmission
- Make call from i-mode web page : You are not making videophone call after connecting to site
provided by IP (Information Provider)
- Upper limit exceeded. Connection failed. : Upper limit of a charging plan with a limiting
function (Type Limit or Family Wide Limit) is exceeded
If a videophone call accompanied with Chaku-moji is made when Auto redial as voice
in Operation is set to "ON", Chaku-moji accompanies when redialing.
Any videophone call from FOMA terminal to emergency call (110, 119 or 118) with Auto
redial as voice in Operation set to "ON" is automatically switched to a voice call.
On hold
The caller is charged for time spent on hold.
During a call, g
1
The call is put on hold, light blinks in green, and a melody is played. For a
videophone call, the videophone on-hold image is displayed on the phone of
the other party and yourself.
To clear voice call on hold, press g or n.
To clear videophone call on hold, perform any of the operations below.
g : Redisplay the image sent before the call is put on hold
I : Camera image is sent
a / n : Substitute image is sent
While on hold, FOMA terminal vibrates every 3 minutes, up to 5 times.
However, it does not vibrate in Public mode (Drive mode) or while Vibrate
alert in Personalized silent mode is set to "OFF".
Using speakerphone function
Enter a phone numberen (1 sec. or more) or C
1
appears at the top of the display.
For operating from phonebook, Redial, Received calls, Recorded messages or
Voice memos, press n (1sec. or more) or I.
Press C for 1 second or more to use speakerphone while Speakerphone in
Operation is set to "OFF".
While making a call, ringing or talking on the phone, you can switch the
speakerphone function ON/OFF each time you press n.
If switching to flip style during a call using the speakerphone function, a
message appears indicating that a call is not available. Restore the style to
normal style.
✔INFORMATION
If you switch to speakerphone, the volume may suddenly increase. Use it with FOMA
terminal away from your ears.
Talk to FOMA terminal within approximately 50 cm. If a call is hard to hear from the
speaker due to loud noise around you or the other party, turn the speakerphone
function OFF.
This function can be used in Silent mode.
Adjusting Listen volume during a call
This setting applies to Listen volume in Adjust volume.
During a voice call, j or SD
1
During a call in flip style, S decreases volume and D increases volume.
Voice/Videophone Calls/PushTalk
59