Making A Call/Videophone Call; Videophone Calls - Docomo F-01A Instruction Manual

Making a call/videophone call

Videophone calls

Videophone function is available between terminals that support DOCOMO
videophone. You can send Chara-den or still image as your image, or switch to
camera to send your own or an ambient image.
The other party receives Substitute image set in Videophone image. You can
switch to camera to send your image or change the substitute image. P72
Videophone calls are only available at 64 kbps.
DOCOMO videophone specifications conform to "3G-324M
*1
standard prepared by 3GPP ". The connection with the videophones of different
specifications cannot be established.
*1 3GPP (3rd Generation Partnership Project)
established to develop standard technology specifications for third generation mobile
communications system (IMT-2000).
...
*2 3G-324M An international standard for 3rd generation mobile videophone
Reading screen during a videophone call
Main screen
Sub screen
Icon definitions
- : Zooming
: Sending camera image
: Using Chara-den
: Sending still image : On hold
: Recording message : Recording movie memo
/ : Action mode (Full motion/Semi-motion)
/ / / : Scene mode (Standard/Backlight/Monotone/Sepia)
: Light ON
/ : Sending image quality (Prefer motion speed/Prefer image quality)
58
Voice/Videophone Calls/PushTalk
*2
, an international
...
is an area standardization organization
Setting status icons
Call duration
: Sending Camera-Off images
: Respond and Hold
: Sending/Receiving audio
: Sending/Receiving audio/video
- : Adjusting Listen volume
: Macro shooting ON
: Videophone call switch available
Guidance is displayed at the bottom of the display. Side key operations are
displayed in the guidance after switching to "Camera". P72
Making a call/videophone call
1
Enter a phone number (up to 80 digits)
Always enter area code even when calling from the same city.
c : Delete 1 digit
2
Select a call type
n
Making a voice call :
C
Making a videophone call :
Your own image is displayed while the videophone call is connected.
The charging begins when "Connected to videophone." appears on the
screen.
When ending the call, f
3
✔INFORMATION
<For both voice and videophone calls>
With 2in1 in Dual mode, the caller ID selection screen is displayed. Select "Number A"
or "Number B".
If an announcement requesting caller ID is heard, make a call again after setting your
caller ID to be notified.
<Voice call>
You can make a call by entering a phone number after pressing n. In this case, a call
is made approximately 5 seconds after the phone number is entered.
<Videophone call>
The charges are based on the rate for digital communication not for voice calls even
when substitute image is sent instead of the camera image.
: Sending/Receiving video