Setting Caller Id To Send/Not To Send For Each Call; Sending Tone Signals (Dtmf) - Docomo F-01A Instruction Manual

Making a call accompanied by message
Chaku-moji appears on the incoming call screen of the other party.
Up to 10 sent Chaku-moji are saved to Sent messages. When exceeding the
savable number, record is overwritten chronologically.
When using 2in1, up to 10 sent Chaku-moji are saved to Sent messages for
Numbers A and B, respectively; a total of 20 sent Chaku-moji are saved. Display
differs depending on mode.
1
Enter a phone numberem31eEnter Chaku-moji (up to 10
characters)eCem or I
When the other party receives the message, "Transmission:success" appears
on the calling screen and message transmission is charged.
You can also select from saved or Sent messages.
✔INFORMATION
Message cannot be sent if the terminal of the other party is not compatible with this
function, when Message display settings is set to "Hide all", or while the terminal is
overseas. In these cases, "Transmission:failure" appears and no message transmission
fee is charged. Also, if the terminal of other party is not turned on, is out of service area,
in public mode (drive mode) or if Greeting msg resp time is set to "0 Sec.", a message
cannot be sent and the transmission result is not displayed.
Chaku-moji is sent even within the delay time in Ring alert delay set on the terminal of
the other party, and transmission is charged.
Depending on radio wave conditions, the transmission result may not appear even
when Chaku-moji arrives to the terminal of the other party, and transmission is
charged.
Chaku-moji cannot be sent/received overseas.
With 2in1 in Dual mode, appears in Sent messages of Number B.
186/184

Setting caller ID to send/not to send for each call

Caller ID is your important information. Carefully consider whether you want to
include caller ID information when making a call.
This function is unavailable for PushTalk.
Priority of the method to notify a caller ID P56
186eEnter a phone numberen or C
Notifying your caller ID :
184eEnter a phone numberen or C
Not notifying your caller ID :
✔INFORMATION
In case of international call, caller ID may not be notified depending on connecting
phone companies even when "186" is prefixed.
When making a call by prefixing "186" or "184", the phone number prefixed with that
number is recorded in the redial list.

Sending tone signals (DTMF)

Pause and timed pause are effective only for voice calls.
❖
Entering pause "P"
This function allows you to operate Voice mail at home, to reserve tickets or to
check the balance of a bank account, etc.
1
Enter a phone numbere* (1 sec. or more)eEnter a
numberen
When pressing g after the call is connected, the digits after the pause ("P") are
sent.
❖
Entering timed pause "T"
Timed pause ("T") is used to dial outside line number followed by an extension.
When timed pause ("T") is entered between the phone and extension numbers, the
extension number is dialed with a pause of the predetermined seconds after the
phone number is dialed.
1
Enter a phone numbere# (1 sec. or more)eEnter an extension
numberen
Timed pauses ("T") can be entered in succession.
Each timed pause ("T") is followed by an interval of approximately 1 second.
❖
Sending tone signals (DTMF) during a videophone call
During a call, m9eEnter a number
1
The number you pressed is displayed and the tone signal is transmitted.
c : Cancel sending
While sending camera image or Camera off, a tone signal can be sent by only
pressing numeric keys without pressing m9.
The image set as substitute image is canceled.
Voice/Videophone Calls/PushTalk
63