Using Infrared Remote Control Function - Docomo F-01A Instruction Manual

Prime series
Table of Contents

Advertisement

After phonebook is saved, a confirmation screen for adding to PushTalk
phonebook appears. You can select "Yes" and select a phone number to add
to PushTalk phonebook.
Receiving all data
You can receive data collectively by data type.
The data saved at the receiving side is deleted, and only the received data is
saved.
Enter the same authentication password on the sending and receiving sides.
Decide a 4-digit authentication password in advance.
All items of Decome-Anime templates, images, movies/i-motion, melodies or PDF
data cannot be received via iC transmission.
Receiving all data via infrared communication
m [LifeKit] 212eAuthenticateeEnter 4-digit
1
authentication passworde"Yes"eSend all data from
sendere"Yes"
Receiving all data via iC transmission
1
Send all data from sendereDisplay the stand-by display on the
receiver and place
marks close to each
othereAuthenticateeEnter a 4-digit authentication
passwordePlace
marks againe"Yes"
✔INFORMATION
ToDo data (list function to manage errands) cannot be saved to FOMA terminal. If all
items of ToDo and schedule are received, only the schedule is saved.
Receiving time differs by the type or number of received data items. If you receive large
size data or a lot of data items, receiving may take time.
For some sizes of data saved, the number that can be received becomes fewer than the
savable number of FOMA terminal.
When exceeding the savable number/area (data in Data Box) P312
Mail messages received from a device that can save messages by folder may be saved
in the folder for Message i-αppli. Move the cursor to the folder for Message i-αppli and
m1 to check saved mail.
press

Using infrared remote control function

Download i-αppli applicable to each model for Infrared remote control.
Operations differ by i-αppli.
If activating preinstalled i-αppli G
Controller) ( P249), FOMA terminal can be used as infrared remote control for
TV.
Even devices compatible with infrared remote control may not work.
Communication may also be affected depending on the supported device used or
ambient luminance.
Remote control
To use remote control, point the infrared data port of FOMA terminal at the infrared
receiver of the supported device. Angle for remote control is 15 degrees from the
center and distance is up to approximately 4 m. However, the allowable angle and
distance depend on the operated device or ambient luminance.
Infrared data port
15°
Approx. 4 m
(G-GUIDE TV Remote
15°
Infrared
receiving port
Data Management
315

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the F-01A and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents