Docomo F-01A Instruction Manual page 137

✔INFORMATION
When transmission is complete correctly, the i-mode mail is saved in a folder of
Outbox. When the memory space is not enough or when exceeding the savable
number, the unprotected sent mails are overwritten chronologically.
When Deco-mail pictogram (Pictogram D) is used, the mail is sent as Deco-mail.
Some pictograms may not be displayed correctly depending on the other party's i-
mode terminal model.
When i-mode mail containing pictograms is sent to other company's mobile phones,
the pictograms are automatically converted to similar pictograms on the receivers
terminal. Note that the pictograms may not be displayed correctly on the receiver's
terminal depending on the models and/or functions of the receiver's terminals and they
may be converted to characters or
Under some radio wave conditions, characters are not displayed correctly at the
receiver side.
Even when i-mode mail is sent correctly, an error message "Transmission failed." may
appear depending on the signal quality.
i-mode mail that failed to be sent is saved in "Unsent" folder.
Error messages for address unknown etc. may not be received when mails are sent to
addresses other than DOCOMO.
When the memory space of Outbox/Unsent messages is not enough or when
exceeding the savable number, i-mode mail cannot be created or sent. Delete
unnecessary i-mode mail and/or SMS from the folder of Unsent messages.
To send an i-mode mail using address B of 2in1 as the sender, use WEB Mail. P144
When a mail exceeding 10,000 bytes in process of creation is automatically saved due
to other functions being started etc., some part of it may not be saved.
Adding address
i-mode mail can be sent to up to 5 addresses at the same time (Simultaneous
sending).
There are 3 address types of receivers as below.
: Main receiver
: Other receiver(s) than the main receiver to inform the contents of the mail
: The receiver(s) to inform the contents of the mail without making the mail
address displayed on other receivers' terminals
When no receiver addresses are entered in
The mail addresses entered in address fields of
receiving side. However, they may not be displayed depending on receivers'
terminals, devices, mail software, etc.
if there are no applicable pictograms.
, the mail cannot be sent.
and are displayed on the
1
On the mail creation screen, move the cursor to the receiver
fieldeaeSelect an entry method
When selecting "Mail group", go to Step 3.
Changing address type : On the mail creation screen, move the cursor to the
addressem9eSelect the address type
Deleting an added address : Move the cursor to the address on the mail
creation screenem8e"Yes"
2
Select Address type
3
Enter the address
Deco-mail
Creating and sending Deco-mail
You can create Deco-mail by changing the text font size or background color,
inserting a still image shot, Deco-mail picture or Deco-mail pictogram stored by
default in i-mode mail text.
Decoration example
Font color/Font size
Insert line
Ticker
Word alignment/Insert image/Swing
Background color
Deco-mail can be created in two ways : one is entering characters after selecting
a decoration type ( P136) and the other is selecting a decoration type after
entering characters ( P137).
Deco-mail of 100 Kbytes or less in size can be sent. Images up to 20 types or up
to 90 Kbytes in total can be attached to the text out of 100 Kbytes. Note that Flash
graphics are up to 2 items.
Deco-mail received on an incompatible terminal becomes mail containing a URL
for viewing or mail with only message text depending on the receiver's terminal.
Blinking
135
Mail