Sp And User Tool Settings Required For Installation - Ricoh Aficio 240W Service Manual

SP and User Tool Settings Required for Installation

This is a summary of the important SP settings that are necessary for this
installation.
Quick Reference for Installation SP and User Tool Settings
This is a summary of the SP and User Tool settings necessary for installation. For
more details, see 1.2.3.
Main Machine Installation
SP 2923 002 Cleaning Blade Set Mode
SP 3001 005 ID Sensor Setting – Developer
Initialization
SP 1960 Optional Paper Setting
User Tool General Features> Tray Paper
Size
User Tool General Features> Tray Paper
Type
User Tool Date and Time
User Tool Original Paper Size
Roll Feeder Installation
SP1920 Cut Length Adjustment
SP1001 001 Leading Edge Registration – Roll
Feed
SP1002 001 Side-to-Side Registration – Roll 1
SP1002 002 Side-to-Side Registration – Roll 2
Paper Cassette
SP1001 003 Leading Edge Registration – Cut
Paper Tray
SP1002 003 Side-to-Side Registration – Cut
Paper Tray
HDD Installation
SP4960 015 HDD Connection On/Off
SP4960 003 Formatting
Stamp Board Installation
SP5137 Stamp Function On/Off
SM
Applies a thin layer of toner to the drum. This
prevents scratches on the drum when the machine
power comes on for the first time.
Initializes the ID sensor for auto process control.
Enables installed options: Roll feeder (1 or 2 rolls),
paper cassette. This setting is not necessary if no
paper feed options are installed. (The default setting
is for the manual feed table.)
Sets the paper sizes for the roll(s) installed in the roll
feeder and the optional paper cassette. Do this
setting for the manual feed table (Bypass Tray),
even if no paper feed options are installed.
Sets the paper types for the roll(s) installed in the
roll feeder and the optional paper cassette. Do this
setting for the manual feed table (Bypass Tray),
even if no paper feed options are installed.
Check the date and time setting. If they are not
correct, set the correct date and time.
For NA only. Select either "Engineering" or
"Architecture" (whichever is used most frequently)
for automatic original width detection.
Sets the cut length settings for the rolls installed in
the roll feeder. These settings are different for each
machine. The settings are on a label attached to the
right side of the roll feeder drawer.
Adjust if necessary for Roll Feeder B641/B642.
Adjust if necessary for Roll Feeder B641/B642.
Adjust if necessary for Roll Feeder B642 only.
Adjust if necessary for Paper Cassette B643.
Enables the HDD after it is installed. The machine
will not detect the HDD until this SP is done. This SP
must be done before the HDD can be formatted.
The HDD must be formatted. Formatting requires
about 25 min.
Enables the stamp board after it is installed. The
machine will not detect the stamp board until this SP
is done.
1-5
PREPARATION
B125