Table of Contents
Advertisement
30 March 1999
4. SERVICE TABLES
4.1 SERVICE PROGRAM (SP) MODES
4.1.1 HOW TO ENTER AN SP MODE
Follow the procedure below to enter an SP mode.
ô → ò → ó → ì → E
Reset
How to make a copy in SP mode:
The screen switches to the copy mode when you press the Interrupt key ( M ) in
SP mode. After the copy job is finished, the screen goes back to the SP mode
screen when the Interrupt key is pressed again.
A service program number is composed of the 3 levels (first, second and third).
There are two ways to access a desired SP mode as follows.
Example; 5 – 009 – 002
5 (1 digit):
009 (3 digits):
002 (3 digits):
Method 1. Enter the specific number (first, second, and third levels) of a SP mode
using the numeral keys; and then, press the Enter (#) key. You can go
directly in the specific SP mode.
(Example)
Input "5009002" using the numeral keys and press the Enter (#) key.
Method 2. Select a specific SP mode by scrolling down or up and press the OK
key to go into the next level.
(Example)
Select "5" by pressing the Next key; then press the OK key. Select
"009" by pressing the Next key, then press the OK key. Select "002"
by pressing the Next key.
Method 1 & 2.
Enter the specific number of a SP mode up to the second level
and scroll up or down the screen by pressing Next or Previous
key.
(Example)
Input "5009" using the numeral keys and press the Enter (#) key.
Scroll up or down and select "002".
Press and hold down for 3 seconds
First level
Second level
Third level
4-1
SERVICE PROGRAM (SP) MODES
Advertisement
Table of Contents
