Ptz Setting- Advanced - GeoVision GV-IP Speed User Manual

Starting and Stopping a Sequence Route
To start the GV-IP Speed Dome on a Sequence route, click Option (Figure 4-1) on the PTZ
Control Panel, click Auto and select a Go Sequence number which has been previously set.
To stop a Sequence route in action, click on a direction key, home key, zoom button or focus
button on the PTZ Control Panel.

4.5 PTZ Setting- Advanced

PTZ Idle Protection: When the Dome idles for a period of time, users can select a
function mode to ensure constant monitoring. After the idle time, the selected function
mode will be automatically activated. To configure and enable this function, follow these
steps:
1. Use the PTZ Idle Protection drop-down list to select Setup.
2. Use the Delay Time (Minute) drop-down list to select the time length allowed for the
Dome to remain stationary. The time length can be set from 1 to 128 minutes.
3. Use the Function drop-down list to select the desired function mode. The modes
include:
Preset: When the Delay Time is up, the Dome will automatically move to the
chosen Preset point. To configure a Preset, see 4.1 Preset Settings.
Figure 4-4
PTZ OSD Control Panel
4
59