Installing The Accuload System - GRAPHTEC FC4100 series User Manual

Installing the Accuload System

The Accuload system consists of two media brackets, two stock rollers and one media alignment
bar.
Installation procedure
1. Place the media bracket (right) against the inside surface of the plotter's side box (right).
2. Insert an M4 screw at the second hole from the front side of the plotter.
NOTE: Do not over tighten so that the bracket can rotate easily.
ASSEMBLY TIP: When attaching the bracket on to the cutter, use the foam shipping cover
Do not lay the cutter on it's back side, it may damage the Media Set Lever.
CAUTION:
3. Insert an M4 screw at the third hole from the front side of the plotter.
4. Secure the first screw.
5. Secure the second screw.
6. Repeat steps 1-5 with the Media Bracket (left).
to protect the cutter.
Out of the Box ♦ C1 - 3