GRAPHTEC FC4100 series User Manual page 73

Then the following menu appears.
Use the POSITION Keys to specify a new UR
position. At such time, the X= and Y=
coordinate values respectively represent the
current pen position as X- and Y-axis
displacements from the original origin.
Press the ENTER key to register the newly specified
UR position.
Press the F4 key to select the DEFAULT if you wish to
withdraw the current upper right setting so that the
origin point returns to the original upper right point
which is determined by loaded media size.
Press the MENU key to cancel MENU mode.
NOTE: When the plotter is initialized, your LL and UR settings are erased, and are initialized to
their default position (the lower left and upper right corners of the maximum effective
cutting area) unless CONTINUE is selected at the media type menu.
NOTE: The LL and UR positions cannot be specified outside of the actual area of the loaded
media
NOTE: The effective cutting area can only be set by specifying the lower left and upper right
points. If the effective cutting area is incorrectly specified (for example, by specifying
the Upper Left or Lower Right point or specifying the same point for both UR and LL
positions), the message below appears for several seconds. In this case, reset the
effective cutting area.
NOTE: When the ROTATE and MIRROR mode is selected or canceled after specifying new
LL and UR positions, your LL and UR settings are initialized to their default positions.
NOTE: The effective cutting area cannot be specified past the origin in the direction of media
feeding.
Advanced Functions and Settings ♦ C4 - 11
ILLEGAL PLOT AREA
SET UPPER RIGHT
X= 0 mm
Y= 0 mm
DEFAULT>