Chapter 9 Options; Fc4100 Pounce Tool Manual - GRAPHTEC FC4100 series User Manual

Chapter 9 Options

The following are the FC4100 option user manuals.

FC4100 Pounce Tool Manual

Pouncing is a method used to create a punched outline on media. This is done by inserting a
special tool in the plotter that produces holes instead of plotting with a pen or cutting with a blade.
This outline or pattern has many uses such as aligning letters on a large job or creating a chalk
outline for graphics that will be hand-painted.
The pounce tool has a small point that is pressed into the media. The pounce conditions are set
from the conditions menu.
Force: Sets the hole punching force during pouncing.
Speed: Sets the traveling speed of the lowered pouncing tool.
Quality: Sets the acceleration rate of the pouncing tool.
Offset: Sets the spacing between holes in mm units.
WARNING: To prevent bodily injury, handle the pouncing tool with care.
n
Pounce tool points are very sharp. While handling the
pounce tool be careful to avoid cutting your fingers or other
parts of your body.
Options ♦ C9 - 1
Sharp