Notes On Working Environment - GRAPHTEC FC4100 series User Manual

Notes on Working Environment

Be sure to observe the following notes in the working environment of your plotter:
n
Avoid use or storage of the plotter in places
subject to direct sunlight or the direct draft
from air-conditioning.
n
Avoid locations that are extremely dusty.
n
Prior to cutting, ensure that no obstacles
are placed in the vicinity of the pen
carriage or loaded media.
Impeded movement of the pen carriage or loaded media may prevent accurate
CAUTION:
cutting, or may trigger the position alarm to reset the system or system
overload. An overloaded system triggers the product's circuit protection.
Should the system overload, causing the power to shut down, turn off the power
switch and unplug the power cord. After 5 to 10 minutes, connect the power
and turn on the system. For more information, see Chapter 6 Test Modes and
Troubleshooting.
n
To prevent malfunctions of the
plotter's sensors, position the plotter at
least one meter (3 feet) away from
fluorescent lamps, electric lamps and
any other source of indoor illumination.
Special Precautions ♦ SP - 6