GRAPHTEC FC4100 series User Manual page 38

The position of the Middle Pinch Roller on the FC4100-100 and FC4100-130
CAUTION:
Cutting Plotters effects the cutters performance.
n
If the middle pinch roller is not positioned in the center range of the media AND located over
the grit roller, the media will not feed evenly.
Good Pinch Roller Position
When cutting narrow media that is 10 inches or smaller, the position of the Left
CAUTION:
and Middle Pinch Rollers will effect the performance of the FC4100-100 and
FC4100-130 Cutting Plotters.
n
Lower the media set lever to raise the pinch rollers.
n
Move the left pinch roller next to the middle pinch
rollers.
n
Move both the left and middle pinch rollers together
until they reach the right stop.
n
Load the media so that the left side of the narrow
media under the left pinch roller.
n
Adjust right pinch roller over the right side of the
media.
n
Raise the media set lever to lower the pinch rollers.
Preparing to Cut ♦ C3 - 10
Poor Pinch Roller Position
Good Pinch Roller Position