GRAPHTEC FC4100 series User Manual page 153

Stand Assembly
The following information will give you step by step instructions on how to assemble the Stand for
the GRAPHTEC FC4100 Cutting Plotter. For the best results, please follow all instructions
carefully.
Assembly Area: Assemble the Stand on a secure, flat surface.
Tools: M6 Hex Key
1. Attach Middle Bar to left side of the stand with two M6 x
16mm Socket Cap Screws.
2. Attach Middle Bar to right side of the stand with two M6
x 16mm Socket Cap Screws.
Assembly Tip: If you insert the top screw through the
stand frame, you can quickly align the
middle bar screw holes to the screw
holes in the stand.
3. Insert Cap Plugs over the holes of the four M6 x 16mm
Socket Cap Screws.
4. Lock the Casters.
Options ♦ C9 - 5