Power To The Plotter - GRAPHTEC FC4100 series User Manual

Power to the Plotter

To turn on the plotter, perform the following steps:
1. Make sure that the plotter is turned off (the "O" side of the POWER switch is
depressed).
2. Connect the plotter to a computer and then configure your software application
to the desired interface conditions (if the RS-232C serial interface is used), command mode
and programmable resolution.
3. Connect one end of the power cord provided to an electrical socket of the rated supply voltage
then connect the other end to the plotter's AC line inlet. The plotter's power supply accepts
multi-voltage (100VAC to 240VAC) without changing switches.
4. Turn on the computer.
5. Turn on the plotter (the "l" side of the POWER switch is depressed).
Out of the Box ♦ C1 - 7