Command Error Messages And Their Causes; Error Messages In Gp-Gl Command Mode - GRAPHTEC FC4100 series User Manual

Command Error Messages and Their Causes

Error Messages in GP-GL Command Mode

ERROR 1
COMMAND ERROR
ERROR 4
PARAMETER OVERFLOW
Test Modes and Troubleshooting ♦ C6 - 18
Cause
The plotter received an
unrecognizable command.
•
Noise was input to the
plotter upon execution
of the software
application
•
The software
configuration regarding
the output device has
been changed
•
The plotter's interface
conditions have been
changed.
Cause
A command was received
containing numeric
parameter that exceeds that
command's permissible
range.
•
The software
configuration regarding
the output device has
been changed
•
The plotter's interface
conditions have been
changed
Solution
⇒ Press the ENTER key
⇒ Configure the software
to drive your plotter.
Ensure that the
software's interface
conditions are correctly
set.
⇒ Ensure that the plotter's
interface conditions are
set to match those of
the software.
Solution
⇒ Configure the software
to drive your plotter.
Ensure that the
software's interface
conditions are correctly
set.
⇒ Ensure that the plotter's
interface conditions are
set to match those of
the software.