Pounce Conditions C3 - GRAPHTEC FC4100 series User Manual

Pounce Conditions
To change the setting of a group of conditions, press the function key [F1] to [F4] corresponding
to the number of the group you wish to change. For example, press the F3 key to select
CONDITION 3.
Press the CONDITION key to get into the condition menu.
Press the NEXT key to cancel the condition where you are currently set and return to the main
menu.
To Change the Pounce Force
Press the F1 key to change FORCE. The blinking
cursor indicates that you can change its setting.
Press the UP or DOWN ARROW key to raise or lower
the numeric value from 1 to 35.
Press the F3 key to change QUALITY.
Press the F4 key to change OFFSET.
Press the ENTER key to register your setting.
To Change the Pounce Speed
Press the F2 key to change SPEED. The blinking
cursor indicates that you can change its setting.
Press the UP or DOWN ARROW key to raise or lower
the numeric value from 1 to 90 and +. [1 to 10, 15, 20,
25, 30, 35, 40, 45, 50, 55, 60, 70, 80, 90, +.]
The "+" is 126cm/sec speed.
NOTE: The "+" selection is available with firmware version 1.13 or later.
Press the F1 key to change FORCE.
Press the F3 key to change QUALITY.
Press the F4 key to change OFFSET.
Press the ENTER key to register your setting.
Preparing to Cut ♦ C3 - 30
SET
CONDITION 3
POUNCE
SET
CONDITION 3
POUNCE
17z z
30
4
1
17
30z z
4
1