To Change The Pounce Quality C3; To Change The Pounce Offset C3 - GRAPHTEC FC4100 series User Manual

To Change the Pounce Quality
Press the F3 key to change QUALITY. The blinking
cursor indicates that you can change its setting.
Press the UP or DOWN ARROW key to raise or lower
the numeric value from 1 to 8. The smaller the value,
the higher the quality.
Press the F1 key to change FORCE.
Press the F2 key to change SPEED.
Press the F4 key to change OFFSET.
Press the ENTER key to register your setting.
To Change the Pounce Offset
Press the F4 key to change OFFSET. The blinking
cursor indicates that you can change its setting.
Press the UP or DOWN ARROW key to raise or lower
the numeric value from 1 to 99.
Press the ENTER key to register your setting.
NOTE: For the Pounce Condition, the Cutter Offset refers to the spacing between holes in mm
units.
Preparing to Cut ♦ C3 - 31
SET
CONDITION 3
POUNCE
SET
CONDITION 3
POUNCE
17
30
4z z
1
17
30
4
1z z