Cylinder Head - Remove - Perkins 1106D Disassembly And Assembly

116
Disassembly and Assembly Section
End By:
a. Install the valve mechanism cover. Refer to
Disassembly and Assembly Manual, "Valve
Mechanism Cover - Remove and Install".

Cylinder Head - Remove

Removal Procedure
Start By:
a. If necessary, remove the secondary fuel filter and
the fuel filter base. Refer to Disassembly and
Assembly Manual, "Fuel Filter Base - Remove
and Install".
b. If necessary, remove the fuel priming pump and
the primary fuel filter. Refer to Disassembly and
Assembly Manual, "Fuel Priming Pump - Remove
and Install".
c. Remove the exhaust manifold. Refer to
Disassembly and Assembly Manual, "Exhaust
Manifold - Remove and Install".
d. Remove the fuel manifold. Refer to Disassembly
and Assembly Manual, "Fuel Manifold - Remove
and Install".
e. Remove the electronic control module and the
mounting bracket. Refer to Disassembly and
Assembly Manual, "Electronic Control Module -
Remove and Install".
f. Remove the electronic unit injectors. Refer to
Disassembly and Assembly Manual, "Electronic
Unit Injector - Remove".
g. Remove the valve mechanism cover base. Refer
to Disassembly and Assembly Manual, "Valve
Mechanism Cover Base - Remove".
h. Remove the glow plugs. Refer to Disassembly
and Assembly Manual, "Glow Plugs - Remove
and Install".
NOTICE
Keep all parts clean from contaminants.
Contaminants may cause rapid wear and shortened
component life.
Care must be taken to ensure that fluids are contained
during performance of inspection, maintenance, test-
ing, adjusting and repair of the product. Be prepared to
collect the fluid with suitable containers before open-
ing any compartment or disassembling any compo-
i02296682
nent containing fluids.
Dispose of all fluids according to local regulations and
mandates.
1. Drain the coolant from the cooling system into
a suitable container for storage or for disposal.
Refer to Operation and Maintenance Manual,
"Cooling System Coolant - Change" for the correct
draining procedure.
Illustration 233
Typical example
2. Disconnect the upper radiator hose (not shown)
from the water temperature regulator housing (1)
on the cylinder head.
Illustration 234
Typical example
3. Remove the air inlet hose (not shown) from the
inlet connection (3) on the inlet manifold (2).
SENR9983
NOTICE
g01176154
g01175424