1-3] Option; System Wireless—Co Status Display In Standby (Kx-Wt125/126 Only) (Need); System Restart - Panasonic KX-NCP500 Programming Manual

3.48 [1-3] Option

System options can be programmed.
It is possible to clear the master CS information (Master CS Port and Radio System ID) by following the
procedure below in batch mode:
1.
Click Clear Master CS.
2.
Click Yes. To abort the procedure, click No.
If the system data is downloaded to the PBX after the master CS information has been cleared, it is necessary
to register all PSs again in the interactive mode. Master CS information will be assigned automatically when
a CS is connected to the PBX. Without the Radio System ID, PSs cannot be registered.
System Wireless—System ID
Indicates the radio system ID used to register a PS (reference only).
Default
Not stored.
Value Range
Not applicable.
Maintenance Console Location
3.48 [1-3] Option
Programming Manual References
None
Feature Manual References
None
System Wireless—CO Status Display in Standby (KX-WT125/126 only) (Need

System Restart)

Enables the display of a KX-WT125/KX-WT126 PS to be updated when the status of a CO line changes, even
when the PS is idle.
Default
Enable
Note
When upgrading from MPR software version 4.1xxx, the default is Disable.
Value Range
Enable, Disable
Maintenance Console Location
3.48 [1-3] Option
Document Version 2011-10
3.48 [1-3] Option
PC Programming Manual 353