Panasonic KX-NCP500 Programming Manual page 765

CO-CO with DISA—DISA to Private Network
Specifies whether the DISA port of the message card is released when a CO-to-TIE line call using DISA is
established.
To enable this setting, "
set to "Enable".
Setting this to "Disable" will free up DISA ports faster, but prevent DISA being used to detect the end of a call
and disconnect the CO line quickly.
Default
Disable (Release DISA)
Value Range
Disable (Release DISA): The DISA port of the message card is released when a CO-to-TIE line call using DISA
is established.
Enable: DISA stays connected for the duration of the call, to allow detection of the end of the call.
Maintenance Console Location
7.3 [5-3-1] Voice Message—DISA System
Programming Manual References
7.3 [5-3-1] Voice Message—DISA System—Option 1—
Feature Manual References
None
CO-CO with DISA—Fwd/Transfer to Public CO
Enables CO-to-CO line calls to be established using DISA.
Default
Disable
Value Range
Disable: CO-to-CO line calls are established without using DISA.
Enable (Get DISA): CO-to-CO line calls are established using DISA, and DISA can be used to detect the end
of the call.
Maintenance Console Location
7.3 [5-3-1] Voice Message—DISA System
Programming Manual References
7.3 [5-3-1] Voice Message—DISA System—Option 1—
Feature Manual References
None
Document Version 2011-10
CO-CO with DISA—Fwd/Transfer to Private Network" on this screen should be
7.3 [5-3-1] Voice Message—DISA System
CO-CO with DISA—Fwd/Transfer to Private Network
CO-CO with DISA—DISA to Public CO
PC Programming Manual 765