Utility-T1 Signaling Bit Monitor; Utility-T1 Line Trace; Utility-Isdn/Qsig Protocol Trace - Panasonic KX-NCP500 Programming Manual

2.6.11 Utility—ISDN/QSIG Protocol Trace
To view the error log
•
From the Utility menu, select Error Log.
2.6.9 Utility—T1 Signaling Bit Monitor
Displays reference signaling bit information for all channels of the T1 card, by monitoring sent and received A,
B, C and D bits. This utility is intended for use by dealers.
This option is only available at Installer level, and requires that the target T1 card be set to INS status.
While monitoring is being performed, any displayed bits whose value changes from 0 to 1 or vice versa will be
highlighted in red until the next screen refresh is performed.
To view signaling bit information
1.
From the Utility menu, select T1 Signaling Bit Monitor.
2.
From the Slot No drop-down list, select the target slot.
3.
From the Interval Timer drop-down list, select the number of seconds between each automatic screen
refresh.
4.
Click Start.
Monitoring will be performed and the screen will refresh according to the interval specified.
5.
Click Stop to end monitoring.
To refresh the screen at any time while monitoring is stopped, click Refresh.
2.6.10 Utility—T1 Line Trace
Traces the sent and received signaling bits and dial numbers on the specified channel of the T1 line. This utility
is intended for use by dealers.
This option is only available at Installer level, and requires that the target T1 card be set to INS status.
To view T1 trace data
1.
From the Utility menu, select T1 Line Trace.
2.
From the Slot No drop-down list, select the target slot.
3.
From the CH No drop-down list, select the target channel.
4.
Click Start.
Trace information will be displayed. The information is automatically updated whenever the data being
monitored changes.
5.
Click Stop to end the trace.
6.
Select an option:
•
Click Capture to save the displayed trace information.
Information is saved as a text-format file.
•
Click Clear to erase the information.
2.6.11 Utility—ISDN/QSIG Protocol Trace
This utility collects protocol trace data from PRI or IP-GW cards, and displays it on the PC.
This option is only available at Installer level, and requires that the target PRI or IP-GW card be set to INS
status.
Protocol trace data is continually accumulated on ISDN and IP-GW cards, and 3 types of data can be
downloaded:
•
Real Time Trace: Pseudo-real-time data is collected through data polling at one-second intervals. The
displayed information is updated beginning when the Start button is clicked.
•
Accumulation Trace: Previously accumulated data is retrieved and displayed.
58 PC Programming Manual Document Version 2011-10