Panasonic KX-NCP500 Programming Manual page 610

6.1 [4-1-1] Wired Extension—Extension Settings
Value Range
Max. 20 characters
Maintenance Console Location
6.1 [4-1-1] Wired Extension—Extension Settings
Programming Manual References
None
Feature Manual References
None
Wireless XDP
Specifies the extension number of the PS with which Wireless XDP Parallel Mode is established. To enable
Wireless XDP Parallel Mode, the PS must be turned off once and then turned on after assigning this setting.
This setting is not available when the software is in Batch mode. In addition, a PS with PDN or SDN buttons
cannot be used for Wireless XDP Parallel Mode.
When changing the port type of an extension port in
Property - Extension Port screen, the
Default
Not stored.
Value Range
Max. 5 digits (consisting of 0–9)
Maintenance Console Location
6.1 [4-1-1] Wired Extension—Extension Settings
Programming Manual References
None
Feature Manual References
20.1.5 Wireless XDP Parallel Mode
Ring Pattern Table
Specifies the Ring Tone Pattern Table to be used by the extension.
Default
1
Value Range
1–8
610 PC Programming Manual
DPT Type—Type on the 3.24 [1-1] Slot—Port
Wireless XDP setting must be deleted first.
Document Version 2011-10