Table of Contents
Advertisement
IFS-2600 Fire Indicator Panel
5.1. Program Mode
Press the following buttons in order shown to enter programming mode.
PREVIOUS
Programming Mode
The liquid crystal display will display all messages and prompts required to program the IFS-2600 Panel.
Only the "PREVIOUS","NEXT","SELECT","EXIT" AND "ENTER" keys are used in programming mode. All
other keys will give an error beep and should be ignored.
Alarm detection is not affected during the programming function but you must exit programming mode if
any other panel functions are to be performed including acknowledge and reset of alarms.
NOTE: Refer to appendices for detailed explanation of functions.
Programming Hierarchy
Zones
STD LATCHING
STANDARD LATCHING AVF
NON LATCH
NON LATCH 20S
TIME DELAY 10S
TIME DELAY 20S
TIME DELAY 30S
TIME DELAY 40S
TIME DELAY 50S
TIME DELAY 60S
DOC-01-009
Section 5 - Programming
→
→
NEXT
YES
ZONES
GLOBAL
TYPE
SELECT
EXIT
SAVE CHANGES
NO
RELAY
PRINT
INDICATE
I BELL
IB GENERAL
IBG ACF OUT
IBGA BRIGADE 1
IBGA BRIGADE 2
IBGA BRIGADE 1 & 2
Section 5 Programming
→
→
EXIT
OUTPUT
ENTER
36
Advertisement
Table of Contents
