Table of Contents
Advertisement
dummyhead
ADJUSTMENT AFTER INSTALLATION
Trim Tab Adjustment
Single Motor
After the engine break-in, run the boat at full speed and check to see
if the boat pulls to the left or right. Adjust the trim tab as required to
ensure good and straight running characteristics.
• If the boat pulls to the left:
Loosen the trim tab lock bolt [1], and move the trim tab trailing
edge [2] to the left.
• If the boat pulls to the right:
Loosen the trim tab lock bolt [1], and move the trim tab trailing
edge [2] to the right.
BF175D/BF200D/BF225D/BF250D
Pulling to the left
[2]
[1]
Pulling to the right
[2]
[1]
33
Advertisement
Table of Contents
