Tiller Handle Height/Angle Adjustment (H Type) - TOHATSU BFT 80A Owner's Manual

PRE-OPERATION CHECKS
Tiller Handle Height/Angle
Adjustment (H type)
The tiller handle height and angle can
be adjusted to three positions by
changing the installation direction of
the height adjustment block. Select a
suitable height and angle for the
operator and secure the block.
<Height/Angle Adjustment
Procedure>
1. Raise the tiller handle and remove
the 8 × 28 mm flange bolt and the
height adjustment block.
2. Pull down the tiller handle.
Determine the height adjustment
block installation direction and
secure the block with the 8 × 28
mm flange bolt.
68
(H1 type)
HANDLE ANGLE: 13°
HANDLE ANGLE: 7°
Install the height adjustment block
so that the selected angle of the
tiller handle is in this position.
HEIGHT
8 × 28 mm
ADJUSTMENT
FLANGE BOLT
BLOCK
HANDLE
ANGLE: 21°
HANDLE ANGLE: 7°
HANDLE ANGLE: 13°
HANDLE ANGLE: 21°
298 mm
(11.7 in)
361 mm
(14.2 in)
438 mm
(17.2 in)
HEIGHT
Reference point