Communication; Projector Address - Digital Projection TITAN sx+ 3D Dual 3D Ultra Contrast User Manual

For important information about how to control the projector when Input 8 is being used, see the final pages of Section 4.
4. Controlling the projector 4. Controlling the projector
Setup menu continued

Communication

• Press and to select Comunication.
Press to open the Comunication submenu.

projector Address

The projector and the remote control need to be set to matching addresses. Read
the note to the right on this page, and follow the instructions in the order shown
below:
1 Set the projector address:
Press to open the Projector address control box.
Press and to select the address setting.
Press and to adjust the address from:
00 to 99
Use and to select from
Apply
Press to apply the new Projector Address.
or Cancel
Press or to exit without making the change.
2 Set the remote control address as shown in Using the control keys, earlier in
this section.
Page 4.44 Page 4.44
Digital Projection Digital Projection
TITAN sx+ 3D, Dual 3D, Ultra Contrast TITAN sx+ 3D, Dual 3D, Ultra Contrast
User Manual User Manual
Notes
Setup Menu
Comunication
When fresh batteries are
inserted in the remote control,
it will default to address 00.
Remote control 00 is a master
control, able to control all
projectors.
If two or more projectors are set
to the same address, they can
be controlled from one remote
control, provided they are
connected by cable or in range
of the infra red.
Rev A August 2009 Rev A August 2009