Lamp Power; Lamp Mode; Cancel - Digital Projection TITAN sx+ 3D Dual 3D Ultra Contrast User Manual

For important information about how to control the projector when Input 8 is being used, see the final pages of Section 4.
Digital Projection Digital Projection
TITAN sx+ 3D, Dual 3D, Ultra Contrast TITAN sx+ 3D, Dual 3D, Ultra Contrast
Setup menu, Lamp continued

Lamp power

• Press and to select the Lamp Power setting.
Press and to adjust the Lamp Power from:
80 to 100%

Lamp Mode

• Press and to select Lamp Mode.
Press and to select from:
single lamp modes
Lamp 1 lamp 1 only
Lamp 2 lamp 2 only
Alternate on power up, selects the lamp with the least hours used
dual lamp mode
Lamps 1 and 2
OK
• Press and to select OK.
Press to apply the new settings.

Cancel

• Press and to select Cancel.
Press or to exit without applying the new settings.
The indicators on the control panel will show as follows:
Lamp 1 off = OFF
flashing red = LAMP ERROR
flashing green = LAMP WARM-UP
Lamp 2 off = OFF
flashing red = LAMP ERROR
flashing green = LAMP WARM-UP
Rev A August 2009 Rev A August 2009
in 1% steps
both lamps
green = ON (100%) amber = (80 - 99%)
flashing amber = COOL-DOWN
green = ON (100%) amber = (80 - 99%)
flashing amber = COOL-DOWN
User Manual User Manual
For Dual models in single lamp
mode:
- if the running lamp fails, the
other lamp will automatically be
switched on.
The Lamp 2 and Alternate
settings apply only to Dual
models.
The selected lamp mode:
- will not be applied until OK is
selected
- will be applied gradually over a
period of 30 seconds
- will not be applied until the end
of any warm-up or cool-down
period that has already started.
4. Controlling the projector 4. Controlling the projector
Notes
Page 4.41 Page 4.41