Restore Defaults; Centre Lens - Digital Projection TITAN sx+ 3D Dual 3D Ultra Contrast User Manual

For important information about how to control the projector when Input 8 is being used, see the final pages of Section 4.
Digital Projection Digital Projection
TITAN sx+ 3D, Dual 3D, Ultra Contrast TITAN sx+ 3D, Dual 3D, Ultra Contrast
Setup menu, continued

Restore Defaults

• Press and to select Restore Defaults.
Press .
The following message will be displayed.
Press and to select from:
Yes
Press to confirm your that you really wish to restore all default settings.
• All settings will be restored to factory defaults.
or No
Press or to exit without making the change.

Centre Lens

to select Centre Lens.
• Press and
Press to centre the lens.
Rev A August 2009 Rev A August 2009
User Manual User Manual
Restore Defaults will restore
all settings to factory
defaults. All ISF settings will
be lost (see next page).
If you are not sure this is
what you want to do, then
either:
make a record of all settings
first
or
select No, then press
Following a restore to factory
defaults, the projector will
perform a self-test and enter
Standby mode.
This process will take up to 10
seconds. During this time the
projector will not respond to any
commands.
When complete, all settings will
be restored to factory condition
and all user settings will be
removed except for downloaded
colour and gamma parameters.
4. Controlling the projector 4. Controlling the projector
Notes
.
Page 4.53 Page 4.53