Colour Mode; Colour Temperature; Rgb Lift; Rgb Gain - Digital Projection TITAN sx+ 3D Dual 3D Ultra Contrast User Manual

For important information about how to control the projector when Input 8 is being used, see the final pages of Section 4.
Digital Projection Digital Projection
TITAN sx+ 3D, Dual 3D, Ultra Contrast TITAN sx+ 3D, Dual 3D, Ultra Contrast
Colour menu continued

Colour Mode

• Press and to select Colour Mode.
Press and to select from:
Global
Temperature
User
Peak
Video
Film
Graphic
ColorMAX User 1
ColorMAX User 2

Colour Temperature

• Press and to select Temperature.
Press and to adjust the slider (3,000K to 10,000K. in 100 steps).

RGB Lift

• Press and to select the parameter to be adjusted.
Press and to adjust the slider.

RGB Gain

• Press and to select the parameter to be adjusted.
Press and to adjust the slider.

Component Type

• Press and to select Component Type.
Press and to select from:
RGB
YPrPb
Rev A August 2009 Rev A August 2009
User Manual User Manual
Read the notes on Colour and
Global Colourimetry earlier
in this section before making
any settings in the Colour
menus.
Note that any changes made
in the Global Colourimetry
menu (see Setup Menu, later
in this section) will affect ALL
inputs, modes and presets for
which Global Mode has been
selected in the Colour menu.
The Colour Temperature
slider is available only if
Temperature Mode is selected.
The RGB Lift and Gain sliders
are available only if User Mode
is selected.
The Component Type
selection is available for RGB1
and Component inputs only.
4. Controlling the projector 4. Controlling the projector
Notes
Page 4.31 Page 4.31