Communication Setup; Serial Port Baud Rate; Projector Address - Digital Projection TITAN SX+ 3D, DUAL 3D ULTRA CONTRAST User Manual

For important information about how Input 8 is used, see
TITAN sx+ 3D, Dual 3D, Ultra Contrast
Digital Projection
Setup menu continued

Communication Setup

•
Press and to select Comunication.
Press to open the Comunication submenu.

Serial port Baud rate

•
Press and to select Serial Port Baud Rate
Press and to select from:
19200
9600

projector Address

The projector and the remote control need to be set to matching addresses. Read
the note to the right on this page, and follow the instructions in the order shown
below:
1 Set the projector address:
Press to open the Projector Address control box.
Press and to select the address setting.
Press and to adjust the address from:
00 to 99
Use and to select from
Apply
Press to apply the new Projector Address.
or Cancel
Press or to exit without making the change.
2 Set the remote control address as shown in Using the control keys, earlier in
this section.
Rev C April 2011
INPUT 8 in the Notes column
User Manual
Setup Menu
, and also Section 4, Overview.
4. Controlling the projector
Notes
Comunication
When fresh batteries are
inserted in the remote control,
it will default to address 00.
Remote control 00 is a master
control, able to control all
projectors.
If two or more projectors are set
to the same address, they can
be controlled from one remote
control, provided they are
connected by cable or in range
of the infra red.
Page 4.49