Verilink WANsuite 5260 Reference Manual page 88

Endpoint
IP Address
IP Mask
Max Transmit Unit
Cost
RIP Status
Multicast Status
OSPF Status
3-58 W A N s u i t e 5 2 6 0 / 5 2 3 0
Figure 3.46 Circuit Details Screen
Endpoint name. By default, the first circuit is always the LAN circuit. All
other circuits are associated with Endpoint names as defined in the Endpoint
Table Screen on page 3-36.
IP Address of the circuit.
IP mask of the circuit.
Maximum transmit unit this circuit will send at any one time.
Represents the relative time of treatment of an IP packet. This value is used
when there are multiple routes to the same destination. When two or more
routes are available, the one with the lowest circuit cost is selected. A frame
relay circuit should have a higher value than a LAN circuit.
Indicates whether or not RIP is enabled on this circuit.
Values: Enable, Disable
Default: Enable
Indicates whether or not Multicast is enabled on this circuit.
Values: Enable, Disable
Default: Enable
Indicates whether or not OSPF is enabled on this circuit.
Values: Enable, Disable
Default: Disable