Verilink WANsuite 5260 Reference Manual page 156

Wansuite 5260; wansuite 5230
Table of Contents

Advertisement

Protocol Encapsulation
Proprietary Traffic
Type
Proprietary Offset
CIR (bps)
Be (bps)
4-40
W A N s u i t e 5 2 6 0 / 5 2 3 0
Figure 4.33
DLCI Details Screen
The unit uses the first three configuration parameters (Protocol Encapsulation,
Proprietary Traffic Type, and Proprietary Offset) to gather statistics. For in-
band management, "RFC 1490" must be the encapsulation method.
The type of encapsulation used by the FRAD/router connected to the unit.
Values: RFC 1490, Proprietary
Default: RFC 1490
When Protocol Encapsulation is set for "Proprietary," the Proprietary Traffic
Type parameter defines which protocol is encapsulated.
Values: IP, IPX, Ethertype, None
Default: None
When Protocol Encapsulation is set for "Proprietary," the Proprietary Offset
parameter defines the number of octets after the frame relay header where the
proprietary traffic type starts.
Values: 0–64
Default: 0
If a Committed Information Rate is configured here, its value (in bits per
second) will be used instead of the default CIR of the frame relay service.
Values: 0–2048000
Default:0
If an Excess Burst Rate is configured here, its value (in bits per second) will
be used instead of the default excess burst of the frame relay service.
Values: 0–2048000
Default: 0

Advertisement

Table of Contents
loading

Related Products for Verilink WANsuite 5260

This manual is also suitable for:

Wansuite 5230

Table of Contents